The PCA National Drivers Education Committee has updated the Driver Education Minimum Standards.

All DE participants must review this update as it may affect your car and equipment preparation for the upcoming DE season.

The section of the Driver Education Minimum Standards document to take particular attention to is the use of a Head and Neck restraint system commonly known as a HANS device, is now mandatory for both student and instructor when a five, six or seven-point harness are being used. Exceptions and detail for some Four-point systems are also listed in the document.
"The participant should BE AWARE that the addition of such a seat and harness system results in the occupant being fastened upright in the vehicle. Therefore, in order to have a COMPLETE SYSTEM, a properly padded roll bar or roll cage is recommended, and an approved head and neck restraint device is required. A head and neck restraint device certified as meeting the standards of either SFI 38.1 or FIA 8858 or its successor is required.  The use of such a harness system without roll protection and a head and neck restraint device may result in an unsafe environment and is not a COMPLETE SYSTEM. Roll bars or cages and their installation must meet PCA Club Racing Standards.
When using a head and neck restraint device, it is recommended that one follow the SFI Recertification process for the head and neck restraint device. The instructions for this can be found on the device. Additionally, it is recommended that the straps be replaced every five years."

NCR Chief Instructor and DE Committee comments:

  • A Head and Neck restraint system commonly known as a HANS device, is now mandatory for both student and instructor when a five, six or seven-point harness is in use.
  • A suitable roll bar or roll cage is Strongly Recommended when race seats and harnesses are in use but is not mandatory.
    A suitable roll bar or roll cage along with a Race Seats and Harnesses provides the driver and instructor with a complete safety system.
  • It is recommended that sedans and coupes with racing seats and harnesses without a roll bar or roll cage have *functioning factory provided three-point seat belts in the car.
  • Sedans and coupes with racing seats, harnesses and *functioning three-point factory belts that do not have a roll bar or roll cage, are allowed to use factory *functioning belts with an instructor but both occupants must use the same restraint method.
  • Students and drivers that utilize racing seats and harnesses without suitable roll protection and do not have *functioning factory provided three-point seat belts in the car, will not be provided an instructor; this includes check-out rides.

* Functioning three-Point belt requires the same fitment as provided by the stock seat.